Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800)526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
Product ID: 117-0237
MSDS No.
Issued: 01/05/98
Toner for 9060 POD
CP-312
Supersedes:
none
Synonyms
Date:
01/26/98
& Common Toner, Black Tonerer for Lanier
Names:
9060 POD
Prepared by:
Lanier QA/EH&S Department
Uses:
9060 POD
European
Contact:
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
Chemical
Formula:
Mixture
Section 2: Composition / Information on Ingredients
PERCENT
CAS No.
1333-86-4
75214-60-7
EXPOSURE LIMITS
SOURCE
3.5mg/m3 3.5mg/m3
OSHA PEL ACGIH TLV
Carbon black
Polyester resin
Polyester resin
6 - 8
not listed
Trade Secret No.
80100252-5001-P
not listed
n/a
n/a
<94
TSCA Confidential
Wax
Pigment
9003-07-0
31714-55-3
n/a
n/a
not listed
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 1
HEALTH = 1
REACTIVITY = 0
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in Xerographic equipment.
Section 4: First Aid Measures
Remove to fresh air if effects occur. Consult
local medical personnel
Inhalation:
Eye Contact: In case of contact, immediately flush eyes with
water for 5 minutes.
Ingestion: Dilute stomach contents with water. Call a
physician
Skin Contact:
Wash with soap and water.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
1
|
Kyocera Cell Phone K490 User Manual
Lantronix Switch LMS8 A User Manual
LG Electronics Computer Monitor W2241T User Manual
LG Electronics Lawn Mower 29UB65 User Manual
Lincoln Electric Welder SVM156 A User Manual
Linksys Network Router RV0041 User Manual
Magnavox Flat Panel Television 20MF500T User Manual
Makita Staple Gun AT1150A User Manual
Matsui America DVD Recorder DVDR100 User Manual
Meridian Audio Marine Radio 561 User Manual