Liebert Network Card IS WEBRT3 User Manual

Liebert^®IS-WEBRT3 Card^™

Quick Start Guide

INSTALL

• Locate the Liebert IntelliSlot bay on your Liebert equip-

ment. You might need to remove a plastic cover.

• Insert the Liebert IS-WEBRT3 Card into the bay.

• Secure the card with the supplied screws.

• Connect the card to your network with a CAT5 Ethernet

cable.

SET LIEBERT IS-WEBRT3 CARD

PASSWORD

• Insert the Liebert PSI-RT3 Software CD and install Liebert DeskPro-Net Util-

ity on your computer.

• Start Liebert DeskPro-Net Utility by clicking on

Start>Programs>NetAgent>DeskPro-Net Utility. The software will

automatically find and list available Liebert IS-WEBRT3 cards.

• Double-click on a card in the list to launch it.

• Enter an Account (login name) and Password—Record the login and

password and save them in a safe place.

Control

functions

Liebert

IS-WEBRT3

cards found

CONFIGURE LIEBERT IS-WEBRT3 CARD

• Highlight the card in the list and click Configure to change the card’s IP

address, subnet mask, and gateway settings (see your network administrator

for the settings).

TheLiebert IS-WEBRT3 card can be used with DHCP or BOOTP, where the sys-

tem assigns an address, but this makes troubleshooting difficult.

™

• Liebert MultiLink will communicate with the Liebert IS-WEBRT3 card. The

software can be configured to shut down a computer system in response to util-

ity power failure and the UPS’ battery backup time.