Havis Shields Automobile Parts C AS MMP User Manual

C-AS-MMP ANGLED SERIES CONSOLES

INSTALLATION INSTRUCTIONS

FOR MODELS C-AS-1025, 1325, 1525 & 1725

TOOLS REQUIRED:

Standard and Metric Socket Set with 6” Extension

Standard and Metric Wrench Set

Torx driver #T15 and #T20

HARDWARE:

QTY: DESCRIPTION:

PART #:

#8 X 3/8 Black Torx Screw

¼-20 X ½” Pem Stud

¼” Lock Washer

CM86508

GSM32220

GSM31026

GSM30005

¼-20 Hex Nut

PARTS SUPPLIED

CM93569 – Monitor Platform Frame

CM93628 – Support Plate

Pair of Wire Panels

C-AS-MMP

C-AS-MMP-CV

C-AS-MMP-IMP

Monitor Mounting Platform

& Wire Panels Crown Vic

Monitor Mounting Platform

& Wire Panels Impala

Monitor Mounting Platform

INSTALLATION: (Refer to pictures on page 2)

1. Turn console over and remove (2) #8 X 3/8” Black torx screws on bottom of console.

2. Place support plate on bottom of console as shown and replace (2) #8 X 3/8” Black torx screws.

3. Turn console back over and place (4) ¼-20 X ½” pem studs on bottom of support plate and insert

(4) ¼” lock washers and (4) ¼” Hex nuts over studs on inside of console housing, then tighten.

4. Place monitor platform on front side of console and secure with (6) #8 X 3/8” Black torx screws.

5. Place wire panels on front sides of console and secure with (6) #8 X 3/8” Black torx screws.

6. Console is ready for mounting in car.